| Code | Description | 
| 10023 | EEROM Test failure. | 
| 01002D | The Main PCA cannot communicate with the Carriage. | 
| 10040 | Error in Paper-axis Encoder quadrature. | 
| 10041 | Error in Scan-axis Encoder quadrature. | 
| 10042 | Error in Service Station-axis Encoder quadrature. | 
| 10090 | Error in Paper-axis Motor Encoder | 
| 10091 | Error in Paper-axis Motor Encoder | 
| 10092 | Mark Encoder position not detected on Drive Roller. | 
| 11000 | NIB Crash. | 
| 50000 | Lens has problems reading the Mark Encoder on the Drive Roller. | 
| 50001 | Lens has problems reading the Mark Encoder on the Drive Roller. | 
| 06030C | Bad Line Sensor. | 
| 0A0000 | APS Failure. | 
| 0A0010 | APS Failure. | 
| 0A0030 | Problem in Depressurizing Air System. | 
| 0A0040 | APS Failure. | 
| 0A0050 | The Printer has detected a leak in the Tubes System before the life of the System. | 
| 0A0060 | The Printer has detected a leak in the Tubes System after the life of the System. | 
| 0A0070 | The Backup EEROM contents stored in the Hard Disk Drive are not consistent with the ones required by the firmware. | 
| 0B0000 | Bad Ambient Temperature measured. | 
| 0B0001 | Bad Humidity read. | 
| 0B0002 | Bad IDS pressure read. | 
| 0B0003 | ADC0 Internal channels check Failure. | 
| 0B0004 | APS Failure. | 
| 0B0005 | APS Failure. | 
| 0B0006 | The Trailing Cable has been incorrectly connected. | 
| 0B0007 | Unable to detect Vacuum Fan. | 
| 0B0008 | Unable to detect Cooling Fan. | 
| 0B0009 | Unable to detect Aerosol Fan (in the Right Cover). | 
| 0B000A | Primer Shutdown Error. | 
| 0B000B | APS Failure. | 
| 0B000C | Serial Device ADC test failure. | 
| 0B000D | 24 V source test failure. | 
| 0C0030 | Drop Detector Failure. | 
| 0C0032 | Drop Detector not Calibrated for all Printheads. | 
| 0C0040 | Error in Printhead Drop Detection. | 
| 0C1001 | Primer Shutdown Error. | 
| 0D0000 | No Media Profiles Available. | 
| 0D0002 | Insufficient Memory to Initialize HPGL2/RTL. | 
| 0FXXXX | A Firmware Error has occurred. |